T6B brass

[DistantCorduroy]

Just got my T6B and am pretty pumped to send it down range. I noticed that the casing seems rough compared to the usual slick 5.7 case. What changed on the T6B?

[panzermk2]

Casing?

If you mean the case, it's the lacquer coating. The coating varies form batch to batch.

[DistantCorduroy]

Yes, the case was what I was referring to. Thanks for the response. Btw, know of anyone planning performance vids on this new T6 version?

[Buffman]

The T6B is still structurally the same as the old T6, is it not?

[panzermk2]

Nope I tweaked it again.

It will break up easier after barrier penetration. It's more like a T6/S5 32gr./Old LEO Trident 30gr. combo.

Penetration of hard armor and soft is unchanged. I wanted to make sure though they broke up as readily as the older versions.

[DistantCorduroy]

Good stuff! Buffman, I was hoping you'd bite on the notion of a vid on this new iteration. What do you say; think you'll put a little something together?

[Buffman]

I would if I could get my hands on some

[DistantCorduroy]

Don't you know a guy???

[DistantCorduroy]

Jay, it sounds the T6B improvements would make a good Coffee Chat subject.,

[panzermk2]

Yeah but they are minimal.

The biggest change is that the copper rods are annealed differently now and are 90 instead of 80 on the Rockwell hardness B scale.

I have focused the chats on all the PS90 Ringsight and rail stuff. I will do one concerning the T6B and some other goodies including the new brass.

[Cyberfly]

YES! The new brass...now that's what I want to hear about.
Mainly because I've been following this story since you first started reaching out to find it...

[panzermk2]

This video better then any coffee chat!

[DoubleJ]

Going to cover the new, shorter EFK barrels in the next chat? Gonna share your lacquer with us so we can recondition terrible brass from Salida, Colorado?

[panzermk2]

I will talk about the barrels, and sorry my coating is proprietary.

[DoubleJ]

Will you offer a coating service so we can get weathered or Salida'd brass back into service?

[panzermk2]

Will you offer a coating service so we can get weathered or Salida'd brass back into service?

Possibly I have already been approached.

It would have to be large amount and you would need to size, de prime and remove the old coating before sending to me. Otherwise like I told the customer who contacted me my guy in charge of that stuff makes 15 an hour. Re sizing and stripping could get expensive fast if we do it.

[DoubleJ]

Makes sense